1, load does not work

(1) During the day, the controller has light control.

(2) Low battery power.

(3) The wiring is correct.

(4) Remove all of the lines, repeat the above installation process, so that the controller to identify again.

2, the beginning of a few days can be used and after a few days will not work

(1) Solar cell wiring is not correct.

(2) Solar cells are not connected well.

3. Can not be controlled by light

(1) Solar cell wiring is not correct.

(2) Do not set this feature, please reset.

4, boot on the work, can not be controlled by light and can not control

(1) Do not set this feature, please reset.

(2) The ambient light of solar panels is strong enough.

5, work instructions flashing non-stop

The load is short or too large.